Determining the right laser power and speed settings for engraving your charcuterie board involves experimenting with various settings to achieve the desired effect without damaging the wood. Here’s a step-by-step approach:

1. Material Type: Identify the type of wood your charcuterie board is made from, as different woods absorb laser energy differently.
2. Start with Manufacturer Settings: Check your laser engraver’s manual for recommended settings suitable for wood.
3. Test Samples: Cut small samples from the same material and experiment with different power and speed combinations. Begin with low power and higher speed to avoid burning.
4. Power Settings: For engraving, typically use between 10% to 50% of the maximum laser power, adjusting based on the project.
5. Speed Settings: Start with moderate speed, around 300-500 mm/min, and adjust as necessary. Slower speeds allow deeper engraving.
6. Feedback Loop: Analyze the results from your test engravings, noting changes in depth and clarity, until you achieve the desired engraving.

Careful adjustment and testing will lead to optimal results for your charcuterie board.